A pre-shipment inspection is the last point at which a buyer can refuse goods while they are still in the factory’s yard. It is also the document most often requested and least often specified: the purchase order says “inspection before shipment” and nothing else, so the inspector arrives with a default sampling plan and the result settles nothing. This note sets out what the check is built on and where its evidence stops.
It is a sampling plan, not a sweep
A pre-shipment inspection works from a standard sampling scheme — ISO 2859-1, or its Chinese equivalent GB/T 2828.1. The scheme takes a lot size and an inspection level, returns a sample size, and sets acceptance and rejection numbers for each defect class. A common arrangement for consumer goods is general inspection level II with AQL 2.5 for major defects and 4.0 for minor ones, and zero tolerance for critical defects.
The word that decides everything is AQL: acceptance quality limit. It is the defect rate the plan will accept, not a target. At AQL 2.5 a lot can pass with defectives in it, and that is by design. A buyer who expects a clean lot has to specify a tighter AQL, a larger sample, or both — and pay for the inspection time.
What the inspector actually checks
The standard scope is quantity against the packing list, carton dimensions and markings, product appearance against the approved sample or golden sample, a function check on a subset, seal and closure integrity, artwork and label text against the approved proof, barcode scan, net weight or fill volume, batch code and expiry printing, and a carton drop test. Photographs of each finding are part of the deliverable, and the report is only useful if those photographs are dated and tied to carton numbers.
What it cannot see
An inspection does not test the formula. It does not run microbiology, it does not measure pH or viscosity against a specification, and it does not confirm that the preservative system holds for twenty-four months. Those are batch release tests and stability programmes, which is why an inspection report and a private label batch record answer different questions and neither replaces the other.
It also cannot see the future of the pack. A pump that seizes after six weeks in a warehouse, a tube that splits at the seal in cold transit, a label that lifts in humidity — none of these appear in a check done the day before loading. Compatibility and transit testing are separate, and they have to be done before the order, not after it.
Finally, it describes the lot that was sampled. If goods from an earlier run are mixed into the same cartons, the sample may never touch them. That is why inspectors are asked to count cartons and compare carton markings against the packing list rather than simply pulling units from the top layer.
Six lines to write into the purchase order
An inspection clause that can be enforced names the standard and the inspection level, the AQL for each defect class, at least three concrete examples of major and minor defects for that specific product, the point in production at which the check happens — normally after packing and before container loading — who bears the cost of a failed inspection and a re-inspection, and what happens to a rejected lot: rework, replacement or cancellation.
The clause should also fix the approval version. Most disputes we see are not about defects but about the reference: the inspector compares the goods against an artwork file that the brand had already replaced, and the report is worthless in both directions.
Where it fits in the order
Inspection sits between production and freight, and it only works if the documents before it are settled. The wholesale FAQ covers the document set that travels with a shipment and the factory page describes how batches are recorded here. Buyers comparing formats before they order can see the net weights on the body care and face care shelves, which is what a packing list is checked against.
Treat the report as evidence about a sample, on a date, against a named reference. That is narrow, and it is enough — as long as the reference and the sampling plan were agreed before the goods existed.
A FATAZEN example of this in practice: FATAZEN Hand Treatment Duo — Rose Mask Plus Floral Cream.
Leave a Reply