A custom bottle, jar or cap usually needs a mould, and the mould is often the largest single payment in a packaging project. It is also the item buyers ask about last. Who paid for it, who holds it, and what happens when the programme ends decide whether a second order is cheap or starts from zero.
What “the mould” actually is
For injection-moulded parts — caps, pumps, jars, closures — the mould is a steel tool cut to the shape of the part. For bottles, the equivalent is a set of blow moulds plus the preform specification. Both belong to a specific part at a specific size; neither is a general-purpose asset. A tool cut for a 50 ml jar will not run a 30 ml jar, and a cap mould is tied to one thread specification.
Three ownership arrangements, three different risks
Factory-owned. The factory pays for tooling and amortises it into the unit price. Nothing appears on your invoice, the unit price is lower at the start, and the tool stays with that factory. If you later move production, the part does not move with you.
Buyer-owned. You pay for the tool as a separate line, it is invoiced to you, and it should be recorded as your property. The unit price is usually lower because the amortisation is gone. The risk moves to custody: the tool sits in someone else’s building, and you need paperwork that says so.
Shared or part-paid. Common on a first run: the factory contributes part of the tooling cost and the balance is recovered across the first orders. Workable, but only if the recovery terms are written down — how many units, at what rate, and what happens if the order volume never arrives.
What a buyer-owned tool should have on paper
Four items, all short: an invoice that names the tool and its part number; a custody note stating where the tool is stored; a clause on maintenance and who pays for repair or replacement after wear; and a clause on release — under what conditions the tool is shipped to another moulder, and at whose cost. Without the last one, ownership is theoretical.
Ask for a photograph of the tool with its identification mark. A tool that cannot be photographed is a tool that cannot be verified, and a buyer who has paid for tooling without verification is relying on goodwill.
Five questions before the tooling invoice is paid
Is the tool new, or is it an existing tool being reused for your part? Who signs off the first shots, and against what drawing? What counts as a worn tool, and who measures it? If the part is redesigned, is the change quoted as a tool modification or as a new tool? And if the project stops after the tool is cut but before the first order, what happens to it? Each answer belongs in the purchase order, not in an email thread.
Where the artwork fits
Tooling and artwork are separate assets and are often confused. The tool decides the shape; the artwork decides what is printed on it. Decorating a custom part adds a second question — whether the print is applied in-mould, by label, or by screen printing — and each method ties the part to a different supplier. Our note on packaging options sets out which formats need a tool and which use stock components.
How it changes a reorder
Once the tool exists, a reorder is a production slot, not a project: private label runs can quote from the existing tool, and lead time is dominated by components and filling rather than by tool making. That is also the moment to check mould condition — a worn tool shows up as flashing or short shots, and the fix is maintenance before the run, not after.
Carton planning follows the same logic: carton configuration is set once the part dimensions are fixed, and it changes when a tool is remade. Artwork approval runs on a third track, and the approval chain is worth separating from tooling for the same reason: different owner, different document.
When the programme ends
Three outcomes are possible, and only one is written in advance: the tool is shipped to you, it is transferred to another moulder, or it stays where it is and is scrapped on request. Decide which before the first order, because the cost and the paperwork differ sharply. Our wholesale FAQ covers how tooling is handled on repeat orders; the custody clause is the part buyers most often ask us to add afterwards.
Leave a Reply